EastTexasMinis

i dont know if where going to do this or not. iight nick found a wreck ext. cab colly whole fronts gone motor tranny hood bumper grille fenders. for only 1500. me and him are talking about buying it.

i get dash front frame clip and bed. what i want to do. is take the front frame clip and start building me a stock floor body drop with the long bed. then throw my cab and front motor and tranny on it when i am done. sound good?

when u build a stock floor u really need the whole frame to take measurements off of

I am with outkast prez, you are asking for trouble if you dont have the entire frame for measurements.

wen we built my frame we had a whole frame to look at other than the one we were building but as long as u have a whole frame that has not been tweeked by a wreck u can get all the measurments!!! u can build it without but it is guaranteed a headache!!!!!!!!!!!!!!!!!!

well i still have my truck. lol. ill be getting the whole frame but ill be only using the front. then measure off my body mounts where my cab sits and make the new mounts on the new frame. then right after the back wall go up with a 35* and stright back. then put the new bed on since the new frame is going to be 11 inchs longer than what it is now. cuase the bed is 11 inch longer that i am going to use. then make the new bed mounts and such. i know its going to take some time. i am not 100% in to doing this yet. still got to find me a daily. but i think that i am going to stock floor it next year when its paid off!

think drive shaft

got to get one made! the rear end goes back 11 inchs also. so the drive shaft prolly gets 11 inchs added to it

hey of u get that truck can i get the pass telllight that u o me