EastTexasMinis

Ill take it off your hands. Text me at 903-714-3253 with a price and pics. Im in north tyler.

already had a guy get the tank the other day.

i put the bed on to check for clerance. looks like i'm going to have to raise my lower panhard mount some. the passenger side tire gets close to the bed.

http://viewmorepics.myspace.com/index.c ... D=33105091

got some more stuff for my truck. cant wait to put this on.

http://viewmorepics.myspace.com/index.c ... D=33353630

got the upper bag mounts finished.
http://viewmorepics.myspace.com/index.c ... D=33408870

then started mounting shocks.
http://viewmorepics.myspace.com/index.c ... D=33408889

Keep up the good work

decided to ditch the panhard and go ahead with a watts link. i have a few bushings left over for the piviot in the center. do i need to set the bars parallel to the ground at ride height on the watts or does it even matter?? started on my engine compressor mount but i cant go any farther until the new clutch comes in. not bad tho i only have about 150 in my compressor set up.

got to take the truck for a short test drive today after relizeing we forgot lugnuts on the rear of the truck. lol. went back to the shop and put all the lugs on and drove down the road. i rides great now.

Yea its alwasy good to have some lugs. Just ask Mike.

we were planning on putting a hatchet man in the bed of my truck when i get the sheetmetel done so i did a rough (well really rough) cutout on cardboard of an idea i had for the center pivot on my watts link.

http://viewmorepics.myspace.com/index.c ... D=33572104

center pivot template for watts


140 psi in the truck

had to go muddin to get over to the torch

hahahaha that watts pivot is tight!

got the watts mocked up. seems to work great. no binding and i have full lift .

got the bed back on and driveing the truck. it should tuck a 24 easily now. could prolly do 26s if my axle were narrowed.



gonna start on the bed floor now. where is everyone getting their sheetmetal??

mullers in kilgore..903 986 9471...42 bucks for a 4x8 sheet of 16 guage... its on i 20 on the back side of kilgore... like the work too bro... and do you still have you old compressors? if you want to sell em, let me know

my old compressors are shot man not worth haveing. u can get and engine driven pretty cheap tho. i got 2 sheets of sheetmetal but i'm gonna have to wait to do the bed so i can get my engine driven compressor in. ended up tearing my wireing harness the other night while dragging. got it patched for now but im going to totally redo the front later on.